Graco ISPA067AE Manuel d'utilisateur télécharger pdf (Page 73)

1. For ease of installation, extend LATCH

to its maximum length.

2. Position base in vehicle seat as

shown.

3. Thread LATCH through base belt

path normally used for vehicle

seat belt. Make sure that LATCH is

UNDER tongue on base .

Belt must lay flat and not be twisted.

4. Hook Connectors to vehicle lower

anchors. Pull firmly on Connectors to

be sure they are attached

.

5. Tighten LATCH by pushing down

hard on base and pulling the

adjustment belt

.

6. NEVER put two LATCH connectors on

one vehicle LATCH anchor unless

specifically allowed by the vehicle

manufacturer



7. Test infant restraint for secure

installation as described in infant

restraint “Final Safety Check” p.40.

8. Check that the LATCH stays tight and does not slip from the

tightened position. If it does not stay tight, try another

seating position or contact Customer Service.

6.4 Using LATCH to install Base





Tongue





1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 124 125

Pas de commentaire

Graco ISPA067AE Manuel d'utilisateur Page 73