Graco 313788A Manuel d'utilisateur télécharger pdf

313788A

Instructions

Replacement Control Board Kit for:

Ultra Max II 695/795/1095/1595

™

Ultimate Mx II 695/795/1095/1595

™

TexSpray

™

Mark IV, Mark V

- This manual contains kit installation instructions only -

Pressure Relief Procedure

1. Turn pressure to zero.

2. Turn on/off switch to OFF.

3. Unplug power supply cord.

4. Hold metal part of gun firmly to grounded metal pail.

Trigger gun to relieve pressure.

5. Lock gun safety latch.

6. Open pressure drain valve. Leave pressure drain

valve open until ready to spray again.

If you suspect that the spray tip or hose is completely

clogged or that pressure has not been fully relieved after

following the steps above, VERY SLOWLY loosen the tip

guard retaining nut or hose end coupling to relieve pres-

sure gradually. Then loosen it completely. Clear the tip or

hose obstruction.

Installation

NOTE: Replacement Control Board is programmed at

factory. No clipping of resistors is necessary.

1. Perform Pressure Relief Procedure.

2. Remove shroud, disconnect wire connectors

emove control box, and remove control board (refer

to sprayer Repair manual for detailed instructions).

3. Clean old thermal paste off of back of control board

and the mating areas on the sprayer.

4. Apply a thin layer of thermal paste to the two compo-

nents on the back of the control board.

5. Install control board, control box, connect wires, an

ins

tall shroud (refer to sprayer Repair manual for

detailed instructions).

IMPORTANT SAFETY INSTRUCTIONS

For detailed sprayer information and warnings,

see Repair manual included with the sprayer.

SKIN INJECTION HAZARD

System pressure must be manually relieved to prevent

system from starting or spraying accidentally. Fluid

under high pressure can be injected through skin and

cause serious injury. To reduce risk of injury from

injection, splashing fluid, or moving parts, follow

Pressure Relief Procedure whenever you:

• are instructed to relieve pressure

• stop spraying

• check or service any system equipment

• install or clean spray tip

NOTICE

Electrostatic discharges can damage components

on Control board. Use a ground strap when handling

or installing Control board.

1 2

Résumé du contenu

Page 1 - Installation

313788AInstructionsReplacement Control Board Kit for:Ultra Max II 695/795/1095/1595™Ultimate Mx II 695/795/1095/1595™TexSpray™ Mark IV, Mark V- This m

Page 2

2 313788AAll written and visual data contained in this document reflects the latest product information available at the time of publication. Graco r

Commentaires sur ces manuels

Pas de commentaire

Graco 313788A Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pulvérisateur de peinture Graco 313788A. Graco 313788A User's Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pulvérisateur de peinture Graco 313788A