Graco 332235A Manuel d'utilisateur

332235AInstructionsDirect Immersion Kit 16U764 for 2570ES- For installation of tower/bracket -2570ES Models: Refer to operation manual below. Before a

10 332235ATransporting UnitNOTE: Do not transport unit with head in vertical position. When transporting unit securely tie down in vehicle or follow

Parts332235A 11Parts342222a24232019232523232314131313134283582915112791010311161717776ti21176aRef Part Description Qty1 287897 SUPPORT, frame12 287896

Parts 12 332235ADimensions80All dimensions are in inchesti21174ati21175a785941

Notes332235A 13Notes

All written and visual data contained in this document reflects the latest product information available at the time of publication. Graco reserves th

2 332235AFixed Mounting (optional)To prevent damaging the unit when transporting it in a truck or on a trailer, Graco recommends fixed mounting to th

332235A 3Securing Unit to Vehicle BedFor fixed mounting, fasten U-bolts over sprayer frame as indicated in the following illustration.1. Reposition ha

4 332235AGeneral InformationPressure Relief Procedure1. Engage trigger lock.2. Set pump valve OFF. 3. Turn engine OFF.4. Turn pressure to lowest sett

332235A 5Removing Hydraulic Head and Pump1. Follow Pressure Relief Procedure, page 4.2. Allow unit to cool. 3. Remove two hydraulic lines from head an

6 332235AInstalling Direct Immersion Kit1. Install tower/bracket into frame holes.2. Install four retaining screws in frame to hold tower/bracket in

332235A 7Using Direct Immersion 1. Apply pipe thread sealant 119400 over male threads on pump.2. Apply pipe sealant to bushing (34).3. Position 55-gal

8 332235A7. Install intake tube (24). Lock female hose adapter (22) to hold intake tube securely in place. Verify hose adapter gasket (22a) is in pla

332235A 94. Ensure gasket (22a) is in place and install intake tube (24). Lock female hose adapter (22) to hold intake tube securely in place.5. Lower