Graco 3A1215C Manuel d'utilisateur télécharger pdf (Page 4)

Installation

4 3A1215C

Installation

Mount Programmable Skipline

Control

Place the Control in a position that is comfortable and

easy to use. If you decide to mount the control, mount

the 0.50” (13mm) wide mounting bracket to a solid loca-

tion.

Connect the Control Cable

Clean all connections of dirt, burrs, moisture, et. before

connecting them to the system.

Operation

General

• All adjusted values remain in memory during power

down.

• UP/DOWN: Numbers change faster when button is

pressed for more than 2 seconds.

• Standard numbers are adjustable to 1/10 foot.

• Metric numbers are adjustable to 1/50 meter.

• NOTE: The controller must be calibrated in the units

that you desire to use.

• Paint and cycle length are adjustable from 0.0 to

999.9 feet. or 0.0 to 99.99 meter.

• Footage counters read out to 999,999.

• BEAD ON/OFF and PAINT ON/OFF delays are

adjustable.

• Pump output constant is adjustable from 0.0000 to

0.9999 gallons (liters)/stroke.

To reduce the risk of serious injury, mount the

Skipline Controller where it is easily visible and will

not interfere with your view of the road. It should take

no longer to look at the controller than it does to look

at a rear-view mirror.

To reduce the risk of serious injury, make sure that

the Skipline Controller is turned OFF whenever you

service any part of the RoadLazer system or leave

the RoadLazer unattended.

1 2 3 4 5 6 7 8 9 ... 15 16

Pas de commentaire

Graco 3A1215C Manuel d'utilisateur Page 4