Graco TRITON 3D150 Manuel d'utilisateur télécharger pdf (Page 13)

Repair

311688D 13

Repair

Prepare the Pump for Repair

1. Flush the pump if possible, page 11.

2. Relieve the pressure, page 10.

3. Disconnect the air and fluid hoses.

4. Remove the pump from its mounting and take it to

the work bench.

General Repair Notes

Fault Indications

During operation, check for indications of worn or dam-

aged parts, such as:

• major pressure fluctuations

• change in the pump’s operating sound

• irregular operation.

Always replace worn or damaged parts immediately to

prevent additional damage.

Tools Required

• 3, 4, and 6 mm allen wrenches

• 12, 19, and 22 mm open end wrenches

• internal snap ring pliers

• o-ring pick

• needlenose pliers

• vise with soft jaws

• A qualified technician should make all repairs.

• Inspect and clean all parts thoroughly before

reassembly.

• Use only genuine Graco replacement parts,

available from your Graco distributor.

• Be careful not to damage sealing surfaces.

• Replace all o-rings removed from the pump.

• Follow all lubrication, torque, and repair notes

in the repair procedures.

• Do not use silicone or silicone-based grease.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Pas de commentaire

Graco TRITON 3D150 Manuel d'utilisateur Page 13