Graco SMVector - Frequency Inverter Manuel d'utilisateur télécharger pdf (Page 27)

SV01M

Commissioning

4.5 Parameter Menu

4.5.1 Basic Setup Parameters

Code Possible Settings

IMPORTANT

No. Name Default Selection

Start Control Source 0 0 Local Keypad Use RUN button on front of drive to start

1 Terminal Strip Use start/stop circuit wired into the terminal strip.

Refer to section 3.2.3

2 Remote Keypad Only Use RUN button on optional Remote Keypad to start

3 Network Only • Start command must come from network

(Modbus, CANopen, etc)

• SMV models <15HP (11kW) require optional

communication module (refer to the network

module documentation).

• Must also set one of the TB-13 inputs to 9

(Network Enable); see P121...P124

4 Terminal Strip or Local Keypad Allows start control to be switched between

terminal strip and local keypad using one of the

TB-13 inputs. See note below.

5 Terminal Strip or Remote Keypad Allows start control to be switched between

terminal strip and optional remote keypad using

one of the TB-13 inputs. See Note below

6 CTRL button select Allows start control to be switched between

terminal strip and local keypad using the CTRL

button.

NOTE: P100 Selection 6 is applicable to SMV 15HP

(11kW) and higher models only.

WARNING!

P100 = 0 disables TB-1 as a STOP input! STOP circuitry may be disabled if parameters are

reset back to defaults (see P199)

NOTE

• P100 = 4, 5: To switch between control sources, one of the TB-13 inputs (P121...P124)

must be set to 08 (Control Select);

TB-13x OPEN (or not conﬁgured): Terminal strip control

TB-13x CLOSED: Local (P100 = 4) or Remote (P100 = 5) keypad

• P100 = 0, 1, 4, 6: Network can take control if P121...P124 = 9 and the corresponding

TB-13x input is CLOSED.

• The STOP button on the front of the drive is always active except in JOG mode.

• TB-1 is an active STOP input if P100 is set to a value other than 0.

• An fault will occur if the Assertion Level switch (ALsw) position does not match

the P120 setting and P100 is set to a value other than 0.

Standard Reference

Source

0 0 Keypad (Local or Remote) Selects the default speed or torque reference

when no Auto Reference is selected using the

TB-13 inputs.

1 0-10 VDC

2 4-20 mA

3 Preset #1 (P131)

4 Preset #2 (P132)

5 Preset #3 (P133)

6 Network

7 Preset Sequence Segment #1 (P710) Selections 7, 8 & 9 are not valid for PID setpoint

or torque reference.

8 Preset Sequence Segment #2 (P715)

9 Preset Sequence Segment #3 (P720)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 65 66

Commentaires sur ces manuels

Pas de commentaire

Graco SMVector - Frequency Inverter Manuel d'utilisateur Page 27

Commentaires sur ces manuels